Nature Power True Sinewave Inverter 1000w/2000w - Manual (Page 10)

Page 10
5. TROUBLESHOOTING
To trouble shoot the unit, please note the error code display on the main unit and review the
“Understanding the Error Codes” in section 4.
Problem Symptom Solution
No output voltage.
And Status LED is
off.
The unit is off Turn unit ON by following the instruction in
Section 4 to turn unit ON
No power to inverter Check fuse or the Disconnect switch (if
installed) is either blown or turn OFF
No AC output.
Status LED is
Green
GFCI was tripped Check load and reset the GFCI
No Output. Status
LED is in Amber
Check error code on
display
Verify the error condition and make
correction
Products
connected to unit
malfunction or
overheat
Products connected to
unit do not accept
modified sine wave output
(38210, 38215 only)
Products are not compatible with the
modified sine wave output generated by the
NATURE POWER Power Inverter. See “AC
Load on Power Inverter” in Section 4
6. SPECIFICATIONS
Note: Specifications are subject to change without notices.
Specification
Modified Sinewave Series True Sinewave Series
38210 38215 38310 38320
Inverter
AC Output Power 1000W 1500W 1000W 2000W
AC Output Current 8.3A 12.5A 8.3A 16.6A
AC Surge Power (Peak) 2000W 3000W 2000W 4000W
AC Output Voltage 120 VAC / 60 Hz
AC Output Waveform Modified Sinewave True Sinewave
Nominal DC Input Voltage 12.5 VDC
No Load battery draw < 0.6 ADC < 1.2 ADC
DC Input Voltage operating
range
10.5 – 15.5 VDC
Under Voltage Alarm 11.2 VDC
Under Voltage Shutdown 10.5 VDC
Under Voltage Recovery 11.8 VDC
Over Voltage Shutdown 15.5 VDC
USB 5V, 750 mA
Safety and Environmental
Conformance Conforms to UL 458
Certified to CSA C22.2 no. 107.1
Agency Markings cETLus
Operating Temperature 0°C to 40°C (32°F to 104°F)
Storage Temperature -20°C to 60°C (-4°F to 140°F)
Relative Humidity 5-90% noncondensing
Operating Altitude Up to 9,843ft (3000 meters) above sea level
Weights and Dimensions
5.3 lbs
(2.4 kg)
6.9 lbs
(3.1 kg)
6.0 lbs
(2.7 kg)
11.5 lbs
(5.2 kg)