Seed Hawk Raven 2010 - Manual (Page 111)

4
Manual No. 016-3001-003 101
Navigating the Viper Pro Interface
The Comm Port setup can be accessed through the menu setup program. To configure the serial
communications ports, press Menu, Setup, Comm Ports. The following screen will be displayed.
GPS Comm Port Setup
Use the GPS Comm Ports Setup screen to modify the communication settings. These settings include:
• Baud Rate
• Data Bits
• Parity
• Stop Bits
Communication settings must match the receiver settings exactly for proper communication between the Viper
Pro and the connected DGPS unit. Real-time communication strings may also be displayed by the Viper Pro
console.
Use the GPS Comm Port Setup screen to setup:
• Generic (Non-Raven) GPS, also RPR 410, Phoenix 300
• Raven GPS
Generic (Non-Raven) GPS Setup
The Generic GPS option allows the operator to configure the communication settings for the Viper Pro for the
GPS receiver providing GPS data.
Note:
The DGPS Receiver must be powered up and connected to the ‘DGPS’ connector on the Viper
Pro main interface cable (P/N 115-3001-011). The receiver must also output the GGA, VTG, and
either the RMC or ZDA NMEA messages to communicate properly with the Viper Pro.