Seed Hawk Raven 2010 - Manual (Page 14)

Chapter 1
4 Seed Hawk™ Viper Pro™ Installation & Operation Manual
Front Panel
The front panel of the Viper Pro provides easy access to the power button and the USB connection. The
following is a description of the front panel features of the Viper Pro:
FIGURE 2. Viper Pro Front Panel
Press the Power button to start up the Viper Pro console. The console takes approximately 30 seconds to
power up.
A USB Port is conveniently located on the front of the Viper Pro console. Insert a USB flash drive into this port
to transfer compatible Viper Pro files.
Note:
The USB flash drive must be formatted with the Viper Pro file structure. See Chapter 9, File
Maintenance, for setting up the required file structure on your USB flash drive.
File Transfer
The Viper Pro features internal memory to store files for current job and field information. The internal memory
should not be used for long term storage and files should be periodically transferred to a home or office PC for
archiving and printing job reports. When transferring files, use a USB flash drive, or “thumb drive,” with at least
256 MB of memory. USB flash drives may be purchased directly from Raven Industries (1 GB USB Flash Drive
P/N 524-0002-065) as well as many retail locations.
FIGURE 3. USB Flash Drive
Note:
Install the USB flash drive only when you want to transfer files. Do not start the Viper Pro or leave
the USB “thumb drive” in the Viper Pro during normal operations.
NOTICE
Failure to close a job before turning the
console’s power off may result in a loss of
information for that job. Make sure to properly
close any open jobs before shutting down the
console.
Power Button
USB Port
Touch Screen