Spectra Precision FAST Survey Reference Manual - Manual (Page 200)

p198
Back in the REM ELEV screen, your angle, zenith, and distance are shown, along with the remote height and remote
elevation.
 Read Icon:
This allows the user to take additional shots above or below the previously defined base point.
Pressing the Enter key will also repeat this command.
 Store Icon:
This button stores the current target offset point to the job file
 Configure Icon:
This takes you to the Configure settings also found on the EQUIP tab.
 Instrument Icon:
This takes you to the standard Instrument Setup dialog.
Log Raw GPS
This command allows you to log static data to the receiver or a data card (depending on instrument type) for use with
post processing software.
Post Processing (Logging Static Data) for Ashtech in FAST Survey
There are two methods to log static data with an Ashtech receiver. The first is from the Log Static Data button under
the SURVEY tab of the main menu. The second is using Configure Rover and Configure Base, as described below.
Logging Static Data from the Survey Menu
Go to the SURVEY tab, and select the Log Static Data button. The result is a dialog with six buttons, or an error
message stating that the data collector could not connect to the receiver. (If you receive the error message, check
connections on the data card.) From here, one can start a file, leave the file recording (exit), manage files, pause
recording (stop processing), resume recording (start processing), or start tagging sites. To manage files, see below. If a
file is open, but paused, you can choose to resume it here.