Spectra Precision FAST Survey Reference Manual - Manual (Page 42)

p40
offset is entered during stakeout, then two cut and fill results will appear for each point (useful, for example, for top and
bottom of curb).
List Points
This command will list all of the points in the current coordinate (.crd) file. You can also edit any point in the list. If a
Control File is active within Job Settings, Options, then you can also list and edit the Control File. The "From List" icon
also allows you to recall points from both the current Job and the Control File job, if active.
The above figure shows the List Points dialog. The point list includes Point ID, Northing, Easting, Elevation, and
Description. Columns can be shifted to condense the display, as desired. The new positions, however, are not stored.
 Details:
The number of points and highest point number in the file will now appear in the Details option.