Spectra Precision FAST Survey Reference Manual - Manual (Page 51)

p49
The reference point is specified by point ID or by entering the northing, easting and elevation of the reference point.
The process results show varying information depending on selected options from the Process Raw Data Options
dialog box.
 Reference Closing Point ID
: The desired closing point number must be entered into this field. If the closing point
does not exist in the coordinate file, the known coordinates can be entered into the North, East and Elevation fields
on the dialog box.
 Apply Angle Balance
: This option performs an angle balance on the traverse lines before the selected adjustment
routine is processed. With this option enabled, the Angle Balance Shot must be chosen from the Angle Balance
Measurement Dialog box. The adjustment method is applied without angle balance computations.
 Vertical Error Adjustment
: The vertical error between the starting and ending points will be calculated and
displayed in the results screen. An adjustment value is determined and applied to the traverse points proportional to
their measured distance.
 Report Point Adjustment
: The adjusted point coordinates and the original point coordinates will be displayed in
the results display under the adjusted point comparison section.
 Report Unadjusted Points
: Displays «
Feature Code List
This command allows you to define default, ready-to-use descriptions. These descriptions lead to linework drawn within
FAST Survey as well as point symbols. It is important to point out that the drawing of linework and point symbols must
be "activated" within Job Settings, Options, by clicking on "Use Code Table for Descriptions". If this is clicked off,
linework and symbols will not be drawn. FAST Survey ships with "Use Code Table" on. In addition, within Configure,
the option "Show Line Details" will automatically redraw the linework whenever any revision occurs or whenever the
Map screen is selected. So if you had a line drawn from points 101 to 105, but then you edited or resurveyed point 102,
"Show Line Details" will lead to the automatci redrawing of the line whenever the graphics are shown. If this is clicked
off, then you would need to go to the Map screen and select Tools, Field-to-Finish, to update linework.