Van Air Systems Mounting Bracket Kits - Manual (Page 2)

©2000 VAN AIR SYSTEMS INC. 2950 MECHANIC STREET, LAKE CITY, PA 16423 PRINTED IN THE USA
INSTALLING BRACKETS (MB-1 THRU 2-2) INSTALLING BRACKETS (MB-3-2)
Remove filter head from the filter bowl.
Place (1) tie rod into each thru-hole until the threaded ends can be
seen on either side of the filter head.
Place (1) mounting bracket onto each side of filter head, threading tie
rod ends through bracket holes as shown in Figure 3A. (Be sure that
the filter head will be mounted in the correct flow direction).
Place (1) washer onto end of each tie rod.
Thread (1) nut onto end of each tie rod and tighten down with a 12mm
or 1/2 inch wrench. Remove filter head from the filter bowl.
Remove blanking plate from top of filter head
Place (1) mounting bracket on one side of the filter head as shown in
Figure 3B. (Be sure that the filter head will be mounted in the correct
flow direction).
Place (1) screw into each thru-hole going through the mounting
bracket and into the filter head.
Place (1) washer onto each screw inside the filter head.
Thread (1) nut onto each screw and tighten down with a 12mm or
1/2 inch wrench.
Place (1) mounting bracket on the other side of the filter head as
shown in Figure 3B.
Place (1) screw into each thru-hole going through the mounting
bracket and into the filter head.
Place (1) washer onto each screw inside the filter head.
Thread (1) nut onto each screw and tighten down with a 12mm or
1/2 inch wrench. 1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
2950 Mechanic Street
Lake City, PA 16423-2095
Phone: 814/774-2631
Fax: 814/774-3482 MAKING COMPRESSED AIR AND GAS WORK BETTER SINCE 1944.
FIGURE 3A MB-1 THRU MB-2-2 DETAILS (TOP VIEW) FIGURE 3B MB-3-2 DETAILS (TOP VIEW)
HEX NUT
4 PLACES
TIE ROD
2 PLACES
WASHERS
4 PLACES
FILTER
HEAD
MOUNTING
BRACKET
2 PLACES
MOUNTING
BRACKET
2 PLACES
HEX SCREW
4 PLACES
WASHERS
4 PLACES
FILTER
HEAD
HEX NUT
4 PLACES
THIS SIDE FACES
SUPPORT OR
WALL
THREADED
END
THIS SIDE FACES
SUPPORT OR
WALL