WEN 56551 5500 Watt - Manual (Page 14)

11
Attach Handles
The handles attach to the same end of the generator as the feet. To attach the handles to the
generator, perform the following steps:
1. Place one handle onto the upper portion of the generator frame as shown in figure 3.
2. Slide handle with M8 × 40 bolts attached through the hole and secure using an M8 nut.
3. Repeat steps 1 and 2 for the other side.
At this point, gently remove the two wheels from underneath the generator.
a b
Figure 3- handle assembly
Attach Wheels
To attach the wheels to the generator, perform the following steps:
1. Find a wood block or similar item that is 3 inches thick or greater and rest the exhaust end
of the generator on the block as shown in figure 4.
2. Take one wheel shaft, and one M12 nut as shown. Slide the wheel shaft, with the threaded
part facing inward, through the frame. Secure using an M12 nut and the included wrench as
shown in figure 5.
3. Slide the wheel onto the axle and secure in place using a large cotter pin as shown in figure
6. Spread the pin legs apart slightly to help secure the pin in place.
4. Repeat steps 2 and 3 for the other wheel.
At this point, the generator assembly is complete. Gently remove the generator from the wood
block.