WEN 2307 101 Piece Rotary Tool Kit - Manual (Page 4)

4

Keep children and visitors away. All visitors should wear ANSI-Z87.1 approved safety glasses and
be kept a safe distance from work area.

Make workshop childproof with padlocks, master switches, or by removing starter keys.
 Don‟t force the tool. It will do the job better and safer at the rate for which it was designed.

Use the right tool. Do not force the tool or attachment to do a job for which it was not designed.

Wear proper apparel. Do not wear loose clothing, neckties, or jewelry that can get caught in the
tool‟s moving parts and cause personal injury. Non-slip footwear is recommended when working
outdoors. Wear protective hair covering to contain long hair.

Always wear ANSI-Z87.1 approved safety glasses with side shields. Everyday eyeglasses have only
impact-resistant lenses; they are NOT safety glasses.

Secure work. Use clamps or a vise to hold work when practical. It‟s safer than using your hand and
it frees both hands to operate the tool.

Do not overreach. Keep proper footing and balance at all times.

Maintain tools with care. Keep tools sharp and clean for best and safest performance. Follow
instructions for lubricating and changing accessories.

Disconnect all tools. When not in use, before servicing, or when changing attachments, blades, bits,
cutters, etc…, all tools should be disconnected from power source.

Reduce the risk of unintentional starting. Be sure switch is off when plugging in.

Use recommended accessories. Consult the operator‟s manual for recommended accessories. The
use of improper accessories may cause risk of injury.

Never stand on tool. Serious injury could occur if the tool is tipped or if the blade is unintentionally
contacted.

Direction of feed. Feed work into a blade or cutter against the direction or rotation of the blade or
cutter only

Never leave tool running unattended. Turn power off. Don‟t leave tool until it comes to a complete
stop.

Check damaged parts. Before further use of the tool, a guard or other part that is damaged should be
carefully checked to determine that it will operate properly and perform its intended function.
Check for alignment of moving parts, binding or moving parts, breakage of parts, mounting and any
other conditions that may affect its operation. A guard or other part that is damaged must be
properly repaired or replaced by an authorized service center to avoid risk of personal injury.

Protect your hearing. Wear hearing protection during extended periods of operation.

Keep tools dry, clean, and free from oil and grease. Always use a clean cloth when cleaning. Never
use brake fluids, gasoline, petroleum-based products, or any solvents to clean tool.

PROTECT YOUR LUNGS. Wear a face or dust mask if the operation is dusty.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other
construction activities contains chemicals known to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
 Lead from lead-based paints
 Crystalline silica from bricks and cement and other masonry products
 Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce
your exposure to these chemicals, work in a well ventilated area, and work with approved safety
equipment, such as those dust mask that are specially designed to filter out microscopic particles.