WEN 2307 101 Piece Rotary Tool Kit - Manual (Page 9)

9
Sanding Disc Arbor
1. To fit a disc to the Sanding Disc Arbor, unscrew the fitting screw.
2. Remove the screw and washer.
3. Place the required disc over the end of the arbor.
4. Replace the washer and screw.
5. Tighten the screw until the disc is firmly secured.
6. Fit the arbor to the tool as described in “Fitting the Attachments”.
Sanding Drum Arbor
1. To fit a disc to the Sanding Drum Arbor, unscrew the fitting screw.
2. Remove the screw, washer and rubber drum holder.
3. Push the required Sanding Drum on to the rubber drum holder.
4. Ensure that the drum is completely pushed on to the holder so that edges of the drum and holder
are aligned.
5. Replace the drum holder on the arbor.
6. Replace the washer and screw.
7. Tighten the screw until the disc is firmly secured.
8. Fit the arbor to the tool as described in “Fitting the Attachments”.
Polishing Wheel Arbor
1. Push the threaded point of the Polishing Wheel Arbor into the required polishing wheel.
2. Twist the arbor anticlockwise to secure the polishing wheel firmly on to the arbor.
3. Fit the arbor to the tool as described in “Fitting the Attachments”.
4. Occasionally check the wheel during use to ensure it is still secure.
USING THE ROTARY TOOL KIT
1. Always wear face mask, safety spectacles and hearing protection when using the tool.
2. Always inspect the tool and attachments for damage before use. Never use broken grinding discs
or attachments with bent shafts – Discard immediately.
3. For milling or engraving, hold the tool like a pen to allow better control. Ensure the ventilation
slots are kept clear to prevent overheating.
4. For heavier work such as drilling, hold the tool like a hammer.
5. Use the correct attachment for the job.
6. The abrasive stone supplied can be used to sharpen the engraving bit, if required.
7. This tool is supplied with a 1/8" collet (fitted already on the tool) and a 3/32" spare collet.
Always select the correct size of collet.
MAINTENANCE
Warning: Remove the plug from the socket before carrying out any adjustments, servicing or
maintenance.
 Never use water or other liquids to clean the electrical parts of the tool.
 Always clean the tool after use.
 Ensure that the ventilation slots do not become blocked to prevent overheating.
 Remove the dispose of damaged attachments.
 Check that the locking jaw is correctly aligned.