WEN 2301 9.6 Volt Cordless Rotary Tool Kit - Manual (Page 16)

16
Operating Instructions
Flexible Extension
Some work may require more precise control of the tool . For that purpose a
slender flexible extension has been provided . To attach the flexible extension,
remove the collar from the body of the tool . Pull the drive wire out of the flexible
extension 2” to 3” . Remove the collet nut and collet from the rotary tool . Thread
the end of the drive wire thru the collet nut and the collet . Insert the collet in the
hole in the end of the tool shaft . Replace the collet nut on the shaft and tighten
with the collet wrench . Avoid over tightening of the collet nut . Attach the end of
the flexible extension to the tool by using the end of the flexible casing to replace
the collar of the tool shaft . To attach accessories to the flexible extension spindle
insert the “L” bar into the hole in the side of the spindle to keep it from turning
and use the collet wrench to loosen the collet nut .
Light Collar
Some work may require additional illumination for which a special light collar is
provided . To attach the light collar to the tool, remove existing collar from the tool
and attach the light collar . To activate the light collar turn the small on/off switch
located on the light collar .