Aquametrix 2300 Multi-Input Controller User Manual - Manual (Page 11)

N116-133 AquaMetrix 2300 Installation and Operation Manual Page 11
2. Installation and Housekeeping
Mount the 2300 Controller through the front panel, with the gasket on the outside of the
mounting panel. Hook the sliding mounting blocks on each side of the back of the 2300
enclosure and tighten the setscrews against the mounting panel with a torque of 4 in-lbs as
shown in Figure 4. Connect an AC power cord to the power connector labeled in Figure 5.
Figure 4 - Mounting hardware attached to panel with 4 in-lb of torque.
Figure 5 - 2300 back panel. All connections are made via connectors on the back.
Ethernet Connection
Fault LED
System Operating LED
Power On LED
Power 120-220 VAC
Pulse Rate Input
Analog Probe
inputs
Contact Inputs
Relay Outputs
Optional
Card Slot