Aquametrix 2300 Multi-Input Controller User Manual - Manual (Page 36)

N116-133 AquaMetrix 2300 Installation and Operation Manual Page 36
b. Default Gateway: 192.168.7.7
c. Subnet Mask: 255.255.255.0.
Note that the IP address and Default Gateway are the same. That is because the
computer is the gateway.
On the 2300 Controller:
1. On the front panel, go to Menu>Advanced>Network Setup.
2. Select Network Type, and then Fixed (vs. DHCP.) The Fixed Network Setup screen
will appear.
3. Select IP Address and use the resulting keyboard and navigation keys to enter a new IP
Address.
4. The settings for the Subnet Mask and Default Gateway will be the same as for the
computer. However the IP Address will be different. For the above example a working
set of values might be:
a. IP Address: 192.168.7.7
b. Subnet Mask: 255.255.255.0
c. Default Gateway: 192.168.7.1
5. When complete press the Commit and Restart button.
Open a browser on the computer and type in the IP Address given to the 2300 Controller
(192.168.7.7 in the example above). The login screen should appear; see Section 1.5 for the
logging in.
10. Network Setup
Setup/Network Setup brings up four submenus for configuring of the network:
• Ethernet Setup
• Web Server Setup
• TFTP Server Setup
• Email Setup
10.1. Ethernet Setup
The first submenu is Ethernet Setup, allowing you to change from DHCP to Static IP and back
again. Since you are communicating to the 2300 across a well-defined network connection,
changing this and restarting will sever your connection. However, if you are configuring a
system to be used elsewhere, you may set up the Ethernet for this new location using Save to
allow the new settings to take place upon restart at the new location. This function is also
available in the front panel menu system.
By unchecking the “use DHCP” box, three additional boxes will appear for entering the static IP
address, the subnet mask, and the gateway address. After entering, you must Save or Save
and Restart in order for the changes to be saved.
You may also specify one or more DNS server IP addresses, separated by commas (e.g. 1.2.3.4,
5.6.7.8).