Aquametrix 2300 Multi-Input Controller User Manual - Manual (Page 26)

N116-133 AquaMetrix 2300 Installation and Operation Manual Page 26
5.2. Configuring for Email Notification
Clicking on Next after selecting Send at Control Trip Point will bring up a new screen, page
5-A, shown in Figure 19. First select the TO Address from a drop down menu. The user may
select an email address preset at Setup/Network Setup/Email Setup or choose to enter a new
address. The FROM address is preset in the 2300, and may be changed at Setup > Network
Setup > Email Setup > SMTP Connection Setup.
The email Subject may be selected from a drop down menu, which populates the message
with a pre-setup message that may contain system and probe information. Alternatively, the
user may enter a new subject and unique message directly. Enter Next to get to the summary
screen or Add Monitor to open a new monitor screen.
Figure 19 – Probe Configuration Window, page 5A, showing Email notification setup.
Most wireless phone carriers have Email addresses, which allow the content of Emails to be
sent to a phone as a text message. Emails sent by the 2300 may therefore be sent to most cell
phones for instant action, eliminating the delay of checking one’s Email. To use this feature
you must know the cell phone carrier of the recipient, and add to it an Email postfix specific to
the wireless carrier. A list of postfixes for some of the most common US and Canadian carriers
is in Table 3.
For example, sending an email to a Verizon cell number [email protected] will end up as
a text message on the Verizon cell phone with US number (978) 555-1111. If your provider is
not on this list, search the web or ask you cell phone provider for the text email for your
service.