Aquametrix 2300 Multi-Input Controller User Manual - Manual (Page 32)

N116-133 AquaMetrix 2300 Installation and Operation Manual Page 32
Figure 24 – Calibration screens for probes with K Factor scaling.
8.2. Front Panel Relay Set Points
If a relay is previously setup via the Monitor page in the Probe Configuration Wizard, the set
point values for trigger and reset may be changed on the front panel. From the quad Run
screen, hit the right arrow and then down arrow to arrive at the detailed screen of the probe
you want to modify. Hitting Enter will bring up a menu for this probe, shown below.
Figure 25 – Detailed screen and Meter Actions screen for Tank pH probe.
Select Relay Set Points to modify the relay trip point and reset, a screen shown on the left in
Figure 26. Choose which point to modify, and get a numeric keypad entry screen shown on
the right. If the 2300 asks for a passcode, just hit the back navigation button. The saved value
is shown in parentheses. Hit Done to save the value entered.