Avigilon View - Manual (Page 104)

Setting the Analog PTZ Camera's Baud Rate
1. Click PTZ Settings to open the PTZ Settings tab.
2. Select the baud rate from the drop-down menu that corresponds to the serial configuration of the PTZ
camera. If you’re uncertain what the baud rate is, consult your camera manual.
3. Click OK.
NOTE: Some PTZ cameras do not allow you to set a baud rate. If you have this type of camera, select your baud
rate, then press and hold the Stop button until the PTZ autobaud function is completed.
Sending Commands to an Analog PTZ Camera
You can send commands to an analog PTZ camera, such as a certain motion control. For a list of available
commands, consult your camera manual.
NOTE: Execute Serial Command is only available if you are using an analog PTZ camera attached to an analytic
appliance.
1. Enter a command of up to 8 characters. The following characters are allowed:
0123456789ABCDEFabcdef
104 Setting the Analog PTZ Camera's Baud Rate