APC SMARTSLOT DP300E - Manual (Page 18)

12
Configuring via the Monitoring Port continued
Connecting to
the Monitoring
port
To connect locally to the Silcon Triple Chassis, you must
use the Monitoring cable (940-0024C) supplied with the
Silcon Triple Chassis. Connect one end of the cable to the
Monitoring port of the Silcon Triple Chassis, and the other
end to the DTE device.
Establishing
communications
with the Silcon
Triple Chassis
To establish communication with the Silcon Triple Chassis,
perform the following steps in the order given.
1 Set the communication parameters of the DTE
device to 2400 baud, 8 data bits, no parity, 1 stop
bit, and no flow control.
2 Press ENTER or RETURN .
3 The Main menu of the Silcon Triple Chassis
appears.
Main menu:
Figure 8
The following figure shows a sample of the Main menu.
Figure 8:Main menu
Continued on next page