Catskill Craftsmen 1481 - Manual (Page 11)

Make sure holes go toward the bottom of the cart
Nut
Main Assembly
STEP 8
1 Back Assembly, 1 Front
Assembly, 3 Mid/Bot Side
Braces, 2 Glide Support
Braces, 2 Top Side Braces, 1
Large Side Panel Insert, 1
Small Side Panel Insert
Now you have to decide which
side of the cart you want the
pullout cutting board to come
out of.
The illustration shows the
cutting board coming out of
the left side of the cart. You
can have it come out of the
right simply by reversing the
pieces shown. Attach the
braces to the back assembly
using 1 3/4” machine screws
and nuts. Then insert the side
panels into the slots in the
braces. Then attach the front
assembly in the same manner.
Then attach the handles to
brace B4 and the doors using
HDL-M5-25 screws.
B4
B3
B5
B2
LSP
SP
B2
B2
B5
B4
B3
B5
B2 B2
B2
SP
LSP
This step is much easier if two
people work together.
1 3/4” Machine Screw
HDL-M5-25
Make sure you use B3 here (with no handle holes)
above the pullout cutting board.