Catskill Craftsmen 1481 - Manual (Page 8)

B4
Bastion Post & Pin Assembly
STEP 5
4 Legs, 4 Front/Back Braces, 3 Mid/Bot Side Braces, 2 Doors, 1 Back Panel, 2 Top Side
Braces, 2 Glide Support Braces
Tap 3/4” Pins into the ends of all the Braces and the back panel using a hammer, it is ok if pins
are loose. Tap the 1 1/2” Pins into the ends of the Doors with a hammer. The Back Right Leg and the
Front Left Leg are identical, as are the Back Left Leg and the Front Right Leg. Group them together
so that you have 2 sets of opposite legs, one set for the front, one set for the back. For the Front
Legs, screw bastion posts into the third hole from the top and the bottom hole as illustrated. When
seated, holes in posts should be perpendicular with the long edge of the leg. For the Back Legs,
screw bastion posts into the top hole and in the bottom hole as illustrated. The bottom of the leg is the
end with the large hole in it. Tap 1 1/2” pins into the holes the near the bottom end. For the middle
holes you have to choose the height where you want the middle shelf, then tap in 1 1/2” pins.
1 1/2” Pin
Bastion Post
Front Legs Back Legs
1/2” #4
Attach magnet plate so that the bumps face the wood
B3
BP
RD LD
FLL BRL FRL BLL
1 1/2” Steel Pin
Choose from the three holes, the
height where you want the middle shelf.
This can always be changed later.
3/4” Pin
B1
Four of this brace
B5
Two of this brace