Catskill Craftsmen 7237 - Manual (Page 11)

With unit upright, align the slots on the outside of the Drawer Sides with Drawer Glides attached to
the Table Top Sticks. When both sides are aligned, push the drawer all the way in until it hits the Top
Back Brace. This will “Set” the glides. Slowly pull the drawer out, the large part of the Glide will pull
out with the drawer. Secure the Glide to hte Drawer Side withone M4x3/8” Phillips Flange Head
Screw per side. Hole in glide should be lined up with the hole on the inside of the drawer
TIP: If holes aren’t lined up, try closing the drawer all the way, then opening again.
STEP 7
ATTACH DRAWER