Catskill Craftsmen 7237 - Manual (Page 9)

Attach Drawer Back to the Drawer Sides with four 1 1/4” #8 Screws. There are left and right
sides. Make sure the slots that run the length of the sides are aligned with the slot in the Drawer Back
to accept the Drawer Bottom. See illustration 5. Slide in Drawer Bottom, best side up to inside of
drawer. Take the 2 Bastion posts and dip threaded ends in Vegetable Oil. Align the threaded end of
the posts with the post holes located near the ends of the inside of the drawer front. Tap slotted end
of posts with hammer until threads just enter holes, then tighten posts down with Flat Blade
screwdriver. Tighten post until the solid shaft of the post hits the wood. Back the post out about 1/2
turn, until the hole/screwdriver slot in the end of the posts parallel and are in direct line with the long
edges of the Drawer Front.
STEP 5
DRAWER ASSEMBLY
Drawer Bottom
Drawer Back
Left Drawer Side
Right Drawer Side
Drawer Front
Illustration 5
Insert the Barrel Nuts into the Nut Access Holes on the inside of the Drawer SIdes with the
threaded end of the nut facing out. The small slots on the outer lip of the nut show the position of the
holes through the nut sides. align these slots parallel with the long edges of sides. Take the drawer
front and carefully insert the posts into the ends of the brace sides, throught the sides of the nut until
seated. When in proper position, you should see the hole in the post through the threaded end of the
nut. Push nut snug up against the wood in the nut access hole toward the drawer front. Hole should
be slightly off-center toward the drawer front. Insert the set screw and tighten down. Don’t
cross-thread set screws. Set screw should turn easily then engage the side of the post hole. As the
set screw is tightenend, the tip will seek the center of the hole in the post and tighten. The ends of the
sisdes should be tight against the inside drawer front
Attach the drawer handle with two 1” #8-32 MM Pan Head Machine Screws.
Illustration 5A