Catskill Craftsmen 7237 - Manual (Page 6)

Attach Drawer Glides to Table Top Sticks. Look at the Glides, the narrow piece (with 2 sets of 3
holes and a punched out square stop at each end) attaches to the inside of the Table Top Sticks with
the front end of the Glide flush with the front edge of the stick. To make sure you have the front of the
Glide, look at the wide part of the Glide there’s a hole shaped like a pointed triangle the point points
toward the front of the Glide. See illustration 3A. Attach the Glide to the Stick using 5/8” #6 small
Phillips/Flat Head screws. Use 2 screws per Glide, using the 1st and 4th (1st hole in the 2nd series of
3 holes). See illustration 3A. These screws will go into the first and third holes of the stick. The other 2
holes are not used. See illustration 3A.
STEP 3
GLIDE ASSEMBLY
ILLUSTRATION 3A
ILLUSTRATION 3B ILLUSTRATION 3C
This Wider Piece fits into the slot on the outside of the
Drawer Sides and is held in place by one screw from
inside the drawer, screw goes into Black Hole.
This Narrow Piece attaches to the Table Top Stick.
This Narrow Piece is shown separated from the wider
piece for illustration purposes only! The screws go into
the Black Holes.
Front Back