Catskill Craftsmen 61531 - Manual (Page 10)

STEP 12
A. Insert and tap caster sockets with hammer until the
teeth grab the wood. DON’T POUND SOCKET
FLAT OR CASTER SHAFT WILL NOT ENTER.
B. Insert casters and seat by pushing
straight downward with heel or your hand,
or tap into place with a hammer. Don’t be
afraid to give them a good downward
whack on the solid metal part of the
caster!
C. Locking wheels usually go on back,
but can go diagonally or on the front if
cart is moved a lot.
ILLUSTRATION 12
STEP 13
A. Upright Unit. Take bottom
shelf ( no edge banding )
and place it on the set of
back pins. Close doors and
shelf will drop into place.
B. Decide on position of
middle shelf, then tap two
1” pins into each side panel,
making sure the pins on both
sides are in the same relative
position. To remove a pin, use
pliers or claw hammer.
C. Place middle shelf, edge
banding out, on pins.
ILLUSTRATION 13