Catskill Craftsmen 61531 - Manual (Page 9)

STEP 11
A. Stick magnet to magnet plate on right door.
B. With left door open, close the right door. The magnet should be positioned over the wooden block
on the bottom of the top front brace. Hold the magnet in place with your thumb, and open the right door.
The magnet will be in the correct position on the block.
C. Secure magnet with the two round head screws in the magnet packet. Center screws in the slot in
the magnet . This will allow adjustment later, if needed.
D. Do the same for other side.
STEP 10
A. Install doors by inserting pins in
the door tops into the holes in
the long edge top front brace.
B. Place one washer on
each of the door pins in
the door bottoms.
C. Take the bottom front
brace, align pins in door
bottoms with holes along
top long edge of brace
( are washers on pins ? )
and secure brace with
1 3/4” bolts/hex nuts as before.
1 3/4” Phillips Flat Head Bolt (8)
2 Used
in this step
10-24 Hex Nut (8)
2 Used
in this step
2 Used
in this step
3/16” Flat Washer (6)
ILLUSTRATION 10
Magnet (2)
5/8” Pan Head Screw (4)
4 Used
in this step
ILLUSTRATION 11
Make sure you have
the washers in place
on the pins before
you secure the brace.