Catskill Craftsmen 61531 - Manual (Page 6)

1 1/4” Phillips Flat Head #8 Screw (23)
4 Used in this step
Attach a table top stick to the
top of each side panel using
1 1/4” #8 screws. The countersunk
holes (reamed out) in the
stick are positioned as in
illustration 1. Sticks should
be flush with top of panel.
STEP 4
ILLUSTRATION 4
STEP 5
A. Lay back panel flat on a smooth surface with holes up.
B. Attach both side panels with 1 3/4” machine screws
(bolts) and hex nuts. After inserting bolts(s) thru the holes
in the side panels, thru the holes in the long edges of the
back panel, place a hex nut on the tip of your finger, align
nut with bolt and tighten.
C. Look ahead to step 7 which shows side panels
attached to back panel.
1 3/4” Phillips Flat Head Bolt (8)
4 Used
in this step
10-24 Hex Nut (8)
4 Used
in this step
ILLUSTRATION 5
STEP 6
ILLUSTRATION 6
STEPS 6 - 14 WILL BE ACCOMPLISHED WITH THE UNIT TOP
UPSIDE DOWN ( INVERTED ), BUILDING UPWARD TOWARD
THE BOTTOM/CASTER END! BE CAREFUL AS PART
DESCRIPTIONS ARE BASED ON AN UPRIGHT,
COMPLETED UNIT!
A. Invert Table Top on a smooth flat surface and make
a large ( X ) mark over each of the 4 pilot holes in the
bottom. Make marks about 1 1/2” long. These marks
will help you align the cabinet with the pilot holes.
Back
Front