Catskill Craftsmen 61531 - Manual (Page 12)

STEP 16
A. Assemble Knife Rack by inserting four brass colored 1 1/4” #8
Screws through the countersunk (reamed out) holes in the Knife
Rack into the pilot holes in the long edges of the Knife Rack Sides.
Tighten until Seated. Sides will be flush with the bottom of the face
leaving a space at the top.
B. Attach Knife Rack to the other Side Panel with 1 1/4” #8 screws from inside the Side Panel. Place
a washer over each screw.
1 1/4” Phillips Flat Head #8 Screw (23)
2 Used in this step
3/16” Flat Washer (6)
2 used in
this step
4 Used in this step
Use brass screws
C. Tap in the wood plugs in the holes in the Side Panel.
5/8” Wood Plug
1 1/4” Phillips Flat Head #8 Screw (23)