DeFelsko PosiTector 6000 v.6.2 for Basic (1) and Standard (2) models - Manual (Page 16)

16
www.defelsko.com
© DeFelsko Corporation USA 2009
All Rights Reserved
This manual is copyrighted with all rights reserved and may not be reproduced or
transmitted, in whole or part, by any means, without written permission from
DeFelsko Corporation.
DeFelsko, PosiTector and PosiSoft are trademarks of DeFelsko Corporation regis-
tered in the U.S. and in other countries. Other brand or product names are trade-
marks or registered trademarks of their respective holders.
Every effort has been made to ensure that the information in this manual is accu-
rate. DeFelsko is not responsible for printing or clerical errors.
Limited W Limited W arranty arranty , Sole Remedy , Sole Remedy
and Limited Liability and Limited Liability
DeFelsko's sole warranty, remedy, and liability are
the express limited warranty, remedy, and limited
liability that are set forth on its website:
www.defelsko.com/terms
Returning for Service Returning for Service
Before returning the Gage for service…
1.Install new Alkaline batteries in the proper
alignment as shown within battery compartment.
2.Examine the probe tip for dirt or damage. The
probe should move up and down freely.
3.Perform a Gage
Reset (pg.11).
4.Place a plastic shim onto bare metal (steel or non-
steel, depending upon whether you have an "F" or
"N" Gage) and attempt a measurement.
If you must return the Gage for service, describe the
problem fully and include measurement results, if
any. Be sure to also include the Gage, your company
name, company contact, telephone number and fax
number or email address.
Website: www.defelsko.com/support