Delmhorst Instrument Navigator - Manual (Page 10)

Copyright

2007, Delmhorst Instrument Co.
Page 10 of 28
TO SET THE ALARM IN BASIC SCAN MODE:
1. If you wish to set the alarm to beep after a pre-selected relative value is reached, use
the с т keys from the SCAN screen to highlight the ALARM. Press the SELECT key
to enter the alarm sub menu.
2. The default status of the alarm is “OFF.” Press the SELECT key to turn it on.
3. After the alarm is turned on, use the п р keys to scroll up or down to a higher or
lower alarm value.
4. After you have selected the alarm value, use the òkey to highlight DONE. Press
SELECT to get back to the %MC SCAN screen.
Note: Default alarm setting for SCAN mode is 300.
TO RESET THE METER TO DEFAULT SETTINGS IN BASIC MODE:
1. Use the п р keys from the BASIC main menu to highlight #4: DEFAULTS. Press
the SELECT key. The meter will display the following question:
2. Use the п р keys to answer “YES” or “NO.” If you answer “yes,” the meter will
return to factory default settings in basic mode; i.e. Species = Oak, Temperature
correction = 70 F, Alarm = OFF in pin mode. In Scan mode, Alarm = “off.”
TO USE THE METER IN ENHANCED MODE:
To use Navigator in enhanced mode, use the с т keys to highlight #3: ENHANCED. Setting
the meter to enhanced mode requires you to create job definitions and store readings as
described below. The Main Menu in ENHANCED mode is as follows:
NOTE: Although Navigator’s default mode is BASIC, it will remember the mode last saved
at power off, and will remain in the saved mode at next power up.