GW Instek GRF-1300A - Manual (Page 39)

RF Communication and Signals Experiments
Step2
UP
Step3
3. Connect the baseband signal from the output port of the GRF-
1300A to the input terminal of the GSP-730 using the RF wire.
4. Set the GSP-730 as follows:
• Center frequency: 2.5MHz
• Start frequency: 0kHz,
• Stop frequency: 5MHz
• Reference level: 10dBm
• RBW: Auto
Step1 Frequency
F1 2 5
When the first step is done, steps 2 and 3 (below) will
have already been automatically set. Students may do steps 2
and 3 here is for reference only.
Step2 Frequency
0
Step3 Frequency
5
Step4
F1 0
Step5 BW
F1
5.Utilize the Marker function on the spectrum analyzer to
determine the harmonic ratio and draw the spectrum in Table 2-
1.
Step6
Peak
Search
37