GW Instek GSP-730 User Manual - Manual (Page 81)

REMOTE CONTROL
79
Interface Configuration
Configure Remote Interface
USB
configuration
PC side
connector
Type A, host
GSP side
connector
Rear panel Type B, slave
Speed
1.1/2.0 (full speed)
RS232
configuration
PC side
connector
RS232 male port
GSP side
connector
RS232 female port
Baud Rate: 9600, 19200, 38400, 57600,
115200.
Parity: None, Even, Odd, Space, Mark,
Multidrop.
Stop bit: 1, 1.5, 2.
Data bit: 5, 6, 7, 8
Description The GSP-730 can use either the type B USB port
or the RS232 on the rear panel for remote
control.
When using the USB B port, the GSP-730 uses a
USB driver to simulate an RS232 connection
with a PC via USB. It is these RS232 settings
that are configured for remote control.
Before using the USB B port for remote control,
please install the USB driver. See page 20 for
details.