GW Instek APS-1102 Control Software User Manual - Manual (Page 120)

APS-1102 Control Software User Manual
11-6
11.5 Clear Arbitrary Waveform Memory
Selecting [Tool(T)] - [Clear arbitrary waveform memory(C)] displays the [Clear arbitrary
waveform memory] dialog box, shown in “Figure 11-4”. The arbitrary waveform memory for
the specified device can be cleared by selecting the arbitrary waveform number and clicking the
[Clear] button.
Figure 11-4 Clear Arbitrary Waveform Memory Dialog Box
The Clear arbitrary waveform memory function initializes the arbitrary waveform memory as
follows, depending on the wave type:
ARB1 to ARB8:
Sine wave
ARB9 to ARB12: Square wave
ARB13 to ARB16: Triangle wave
11.6 Mode Setting
Select [Tool] - [Set mode] to display the [Set mode] dialog box, shown in “Figure 11-5”.
Click the OK button to make the set values reflected by the device.
If the sequence is in progress, it is not possible to change the “Set mode” setting.
Figure 11-5 Set Mode Dialog Box
For details on setting 1, see the Source APS-1102 User Manual.
！ Caution
！ Caution