GW Instek APS-1102 Control Software User Manual - Manual (Page 35)

4.9 System Setup
4-11
4.9 System Setup
When [Tool(T)] - [System Setup(S)] is selected, the [System Setup] dialog box appears.
Figure 4-13 System Setup Dialog Box
Model Select the model name of the device to be connected.
(Only APS-1102 can be selected.)
Interface Select the external interface of the device to be connected.
(Only USBTMC can be selected.)
Serial NO Input the serial number of the device to be connected.
Set a 7-digit number in the APS-1102.
If this number is not correct, the system cannot communicate with the device.
When [Model], [Interface] and [Serial NO] are set and the OK button is clicked, the software
communicates with the device according to the set conditions. If the communication is established
with the device under the set conditions, the device enters into the online status.
If the communication fails, the following message appears.
Figure 4-14 System Setting Confirmation
If the OK button is clicked, the message and system setup dialog box are closed and the device
enters into the offline status. If the Cancel button is clicked, the system setup dialog box reappears.