GW Instek APS-1102 Control Software User Manual - Manual (Page 32)

4 Basic Controller
19
4.2.6 Limiter Setting
In the limiter setting, you set the current limiters and the restriction on the setting ranges. The default
limiter values held by this software are determined by the model setting in the [System Setting]. Figure
4-9 is an example of limiter settings on APS-1102A.
Figure 4-9 Limiter Setting
In a numerical entry box of the limiter setting, if the entered value is out of the setting range, the error
dialog opens as shown in Figure 4-8. The setting range differs by models. For details of the setting
range, see the instruction manual of the APS Power Source.
4.2.7 Operation Bar
In the Operation Bar, clicking OUTPUT toggles between output on and off of the connected APS
power source. The indication of the OUTPUT button changes as shown in Figure 4-10.
出力オフ状態 出力オン状態
OUTPUT Off OUTPUT On
Figure 4-10 The Indication of OUTPUT Button