GW Instek APS-1102 Control Software User Manual - Manual (Page 41)

APS-1102A Control Software User Manual
28
5.2.4 Step Arrangement
This section describes how to add, insert, delete, move, and copy a step (line).
Figure 5-6 Step Arrangement Buttons
 When the step number is changed for a step that is set as a jump-to step or branch step, the step
number is automatically changed on the calling side of the jump or branching also, preserving the
dependency between steps.
 When a step that is set as the destination of any jump-to step or branch step is deleted, the dialog as
shown in Figure 5-7 appears. When you select Yes, the step is deleted and then the step number of
the jump-to or branch step is automatically updated to disable. If you select No, deletion of the
step is canceled.
Figure 5-7 Confirmation Dialog for Deleting a Step
CAUTION