GW Instek APS-1102 Control Software User Manual - Manual (Page 40)

5 Sequence
27
5.2.2 Tool Bar
On the Sequence Tool Bar, you just click each icon shown in Figure 5-3 to execute the
corresponding function.
Figure 5-3 Sequence Tool Bar
a) New Creates a new sequence setting.
b) Open Opens the sequence setting file.
c) Save Overwrites and saves the sequence setting file.
d) Arbitrary Waveform Editing Shows the Arbitrary waveform editing tool.
5.2.3 Basic Setting
Output mode and Output range
Figure 5-4 Basic Setting (Output Mode and Output Range)
When the output mode or output range is changed, the dialog opens as shown in Figure 5-5. Select Yes
to clear each of the current setting values (reset to the default values). The cleared setting cannot be
undone. If you want to save the current setting before clearing it, select No to cancel the change and
then save the setting to a file ( 5.3).
Figure 5-5 Confirmation Dialog for Clearing the Setting
When you change the output mode or output range setting, it may take some time until the setting is
switched depending on the settings of the APS power source.
a) b ) c ) d )