In-Situ Light Tower Alarm Kit for the Con TROLL PRO System - Manual (Page 2)

800-446-7488 2 www.in-situ.com
Overview
The Light Tower Alarm Kit is designed to work in conjunction with the Con TROLL PRO
System to provide visual and audible indication of the state of the Con TROLL PRO
relay outputs from a distance.
The light tower is controlled via one or both of the Con TROLL PRO low-voltage relays.
Proper operation of the light tower requires correct wiring per one of the application
diagrams in this document as well as relay output programming to match the
configuration.
It is possible to damage the Con TROLL PRO if the light tower is wired incorrectly.
Make sure that you read this document, the Con TROLL PRO Installation Manual, and
the Con TROLL PRO Operator's Manual before installing this product.
Safety Information
Please read this manual and the Con TROLL PRO Installation Manual before
unpacking or installing any part of this kit.
WARNING: This is a low-voltage product and is only to be wired to the
Con TROLL PRO low-voltage relay terminals. This product must not be
wired to the high-voltage terminals in the Con TROLL PRO.
WARNING: Never use this product as a sensing device for personnel
protection. Doing so could lead to serious injury or death. This product
does NOT include the self-checking redundant circuitry necessary to allow its
use in personnel safety applications. A sensor failure or malfunction can cause
either an energized or de-energized relay output condition.
DANGER: Make sure that power to the Con TROLL PRO is disconnected
before making any wiring connections.
DANGER: There is reference in this document to using the Light Tower
functions in conjunction with high-voltage control functions. Only
properly trained and qualified personnel should wire the high-voltage control
functions while observing the precautions in the Con TROLL PRO Installation
Manual.
Compatibility and Reference Manuals
The light tower is compatible with all versions of the Con TROLL PRO: AC, AC-L, and
DC-L.
For Con TROLL PRO units purchased before May 2012, refer to the installation manual
(document number 0087612) and the operator's manual (document number 0087602).
For Con TROLL PRO units purchased after May 2012, refer to the installation manual
(document number 0085660) and the operator's manual (document number 0085670).
Manuals are available on the In-Situ website www.in-situ.com/Manuals.