KEPCO EL Series Electronic Load Operator Manual P/N 243-1295 Firmware Version 3.12 (Unit Rev 2) - Manual (Page 17)

SERIES EL 070110
1-7/1-8 Blank)
TABLE 1-5. ACCESSORIES
ITEM FUNCTION
KEPCO
PART NUMBER
RJ 22 Master/Slave cable, 1 ft.
(See Note.) Daisy chains Series EL loads with the same voltage for
parallel configurations. 118-1245
Fuse 1.5A, SB Required for units configured to run from 240V a-c
source power. 141-0031
(LittelFuse
31301.5)
Slides Allows the unit to slide out of a rack. 108-0474
Side Support bracket Pair required. Used to provide side support for EL
Load. Requires rear rail at 18-13/16 in. setback. 128-1775
NOTE: For units that use slide mounting, consult Kepco for longer cable lengths.
TABLE 1-6. SAFETY SYMBOLS
SYMBOL MEANING
CAUTION: RISK OF ELECTRIC SHOCK.
CAUTION: REFER TO REFERENCED PROCEDURE.
WARNING INDICATES THE POSSIBILITY OF BODILY INJURY OR DEATH.
CAUTION INDICATES THE POSSIBILITY OF EQUIPMENT DAMAGE.
!