Installation, 5 transport 2.6 pre-installation requirements – KROHNE OPTIFLEX 2200 C_F Quickstart EN User Manual
Page 8
2
INSTALLATION
8
OPTIFLEX 2200 C/F
www.krohne.com
08/2013 - 4000622103 - QS OPTIFLEX 2200 R03 en
2.5 Transport
2.6 Pre-installation requirements
• Make sure that there is sufficent space on all sides.
• Protect the signal converter from direct sunlight. The device has a weather protection option.
• Do not subject the signal converter to heavy vibrations.
Figure 2-5: How to hold the device
Figure 2-6: How to hold the device
1 Wind cable probes greater than 400 mm / 16¨ in diameter.
2 Do not hold the probe when you lift the device.
3 Do not wind the electrical cable less than 330 mm / 13¨ in diameter.
WARNING!
If you do not lift the device carefully, you can cause damage to the probe.
INFORMATION!
Obey the precautions that follow to make sure that the device is correctly installed.