KROHNE OPTITEMP TT 50 C-R EN - Manual (Page 12)

3
INSTALLATION
12
OPTITEMP TT 50 C/R
www.krohne.com 09/2010 - 4000636502 - MA OPTITEMP TT 50 C/R R03 en
Installation
3.1 Notes on installation
3.2 In-head transmitter
These transmitters are intended for installation in DIN B connection heads or larger. The large
Ø7 mm / 0.28" center hole facilitates the electrical connection of the measurement sensor and
the installation. For detailed information refer to the chapter "Dimensions and weights".
INFORMATION!
Inspect the cartons carefully for damage or signs of rough handling. Report damage to the
carrier and to the local office of the manufacturer.
INFORMATION!
Check the packing list to check if you received completely all that you ordered.
INFORMATION!
Look at the device nameplate to ensure that the device is delivered according to your order.
Check for the correct supply voltage printed on the nameplate.
1 Screw M4
2 Spring
3 Sensor connection cables
4 Protection tube
5 Lock washer
.book Page 12 Monday, September 13, 2010 5:07 PM