KROHNE OPTISENS PAM 2080 EN - Manual (Page 52)

www.krohne.com 52
Damping the analogue output
Designation Settings Description
Averaging above 000 –100
points
Option for averaging analogue output.
mA simulation 00.00 – 20.00
mA
This value is issued at the analogue output after a power value is entered.
Designation Settings Description
Disp. parameters 00 Number of parameters that are attached to the converter.
Base address 01 – 08 The address that is allocated to the parameter. The address can be changed if
necessary.
Pay attention that no sensor has the same base address. Otherwise the converter cannot
communicate with the sensors without problems.
Second title If required, enter an additional title for the parameter here.