KROHNE OPTISENS AAS 2000 EN - Manual (Page 18)

3
INSTALLATION
18
OPTISENS AAS 2000
www.krohne.com 12/2008 • MA AAS 2000 R01 en
• Insert the PVC rod holder with the telescopic rod into the mounting bracket. Make sure that
the guide tracks of the rod holder are properly seated in the bracket.
• Fasten the safety-locking clamp.
• Check that the mounting bracket is safely fixed to the rail for the spring to work the way it is
intended.
3.4.2 Mounting to MAA 2000 slide rail immersion holder
Figure 3-8: Mounting to MAA 2000 slide rail immersion holder
1 Slide rail immersion holder
2 Sensor
3 66 mm / 2.60" clamp
4 Adjustable stop
CAUTION!
In order to avoid large air bubbles which can affect the measurement please make sure that the
slide rail immersion holder is mounted in a certain angle to the vertical position. The angle
should be slightly off from vertical position (approx. 20°), but not more than 90°.
.book Page 18 Monday, December 15, 2008 12:43 PM