KROHNE OPTISENS AAS 2000 EN - Manual (Page 20)

3
INSTALLATION
20
OPTISENS AAS 2000
www.krohne.com 12/2008 • MA AAS 2000 R01 en
Removing the sensor from MAA 2000 slide rail assembly
• Disconnect the sensor cable from the MAC 080 converter and the flushing hose from the
solenoid valve.
• Pull the sensor out of the slide rail and detach the two clamps.
• Clean the sensor housing with a soft brush or cloth. Do not use a wire brush or sharp tools!
• Mount the protective cap (or a small plastic bag) on the sensor cable connector.
• Blow compressed air through the flushing hose to get rid of the water in the hose and the
sensor.
• Place the plastic cap over electrode and flushing head to protect the membrane.
.book Page 20 Monday, December 15, 2008 12:43 PM