KROHNE IFC 100 Converter EN - Manual (Page 113)

DESCRIPTION OF HART INTERFACE
9
113
IFC 100
www.krohne.com 07/2010 - 4000041004 - MA IFC 100 R04 en
Menu View
Display volume flow / mass flow / flow speed / conductivity / coil temperature / diagnosis value / device
status
Counter counter 1 Opt / counter 2 Opt
Yt diagram volume flow / mass flow
Outputs current output A Opt measured value Opt /
A Opt /
% range A Opt
frequency output D Opt measured value Opt /
D Opt /
% range D Opt
Device Status device C number Rd / device serial no. Rd / electronic serial no. Rd
HART tag / manufacturer Rd / write protect Rd /
model Rd / device ID / universal rev. Rd /
device rev. Rd / software rev. Rd / hardware rev. Rd /
date Rd / final assembly no. Rd / sensor serial no. Rd
Standard (overview) Primary variable out of limits
Non-primary variable out of limits
Primary variable analogue output saturated
Primary variable analogue output fixed
Cold start
Configuration changed
Field device malfunction
Failure (device) F error in device / F IO1 / F parameter / F configuration /
F display / F sensor electronic / F sensor global / F sensor local /
F field current local / F current output A / F software user interface /
F hardware settings / F hardware detection /
F RAM/ROM error IO1
Failure (application) F application error / F empty pipe / F flow rate too high /
F field frequency too high / F DC offset / F open circuit A /
F over range A (current) / F over range D (pulse) /
F active settings / F factory settings /
F backup 1 settings / F backup 2 settings
Out of specification S out of specification / S pipe not full / S pipe empty /
S linearity / S flow profile / S electrode noise /
S gain error / S electrode symmetry / S field coil broken /
S field coil bridged / S field current deviation /
S field frequency too high / S electronic temperature /
S coil temperature / S overflow counter 1 / S overflow counter 2 /
S Backplane Invalid
check request C checks in progress / C test sensor
information I counter 1 stopped / I counter 2 stopped / I power fail /
I over range display 1 / I over range display 2 /
I backplane sensor / I backplane settings /
I backplane difference / I optical interface
Circuit board info
Toolbar
Status Bar
Update
.book Page 113 Friday, July 9, 2010 12:29 PM