KROHNE IFC 100 Converter EN - Manual (Page 46)

6
OPERATION
46
IFC 100
www.krohne.com 07/2010 - 4000041004 - MA IFC 100 R04 en
Operation
6.1 Display and operating elements
Figure 6-1: Display and operating elements (Example: flow indication with 2 measuring values)
1 Indicates a possible status message in the status list
2 Tag number (is only indicated if this number was entered previously by the operator)
3 Indicates when a key has been pressed
4 1st measured variable in large representation
5 Bargraph indication
6 Keys (see table below for function and representation in text)
INFORMATION!
•
It is recommended to activate the push buttons at right angles to the front. Touching them
from the side can cause incorrect operation.
• After 5 minutes of inactivity, there is an automatic return to measuring mode. Previously
changed data is not saved.
Key Measuring mode Menu mode Sub-menu or function
mode Parameter and data
mode
> Switch from measuring
mode to menu mode;
press key for 2.5 s,
"Quick Start" menu is
then displayed
Access to displayed
menu, then 1st
submenu is displayed
Access to displayed sub-
menu or function
For numerical values,
move cursor
(highlighted in blue) one
position to the right
^ - Return to measuring
mode but prompt
whether the data should
be saved
Press 1 to 3 times,
return to menu mode,
data saved
Return to sub-menu or
function, data saved
↓ or ↑ Switch between display
pages: measured
value 1 + 2, trend page
and status page(s)
Select menu Select sub-menu or
function
Use cursor highlighted
in blue to change
number, unit, setting
and to move the decimal
point
Esc (> + ↑) - - Return to menu mode
without acceptance of
data
Return to sub-menu or
function without
acceptance of data
Table 6-1: Description of key functionality
.book Page 46 Friday, July 9, 2010 12:29 PM