Remote operation, 1 remote interface, 2 setting up the rs-232 por – Martel Electronics BetaGauge 301 User Manual
Page 23: Factory setups
Advertising
21
9. Factory Setups
The Calibrator is loaded with five factory setups. These setups are shown below.
Setup 1: The upper display is set to [P1] mode and the middle is set to mA, lower is off.
Setup 2: The upper display is set to [EXT] mode and the middle is set to mA, lower is off.
Setup 3: The upper display is set to [P1] mode and the middle is set to [VOLTS] mode,
lower is off.
Advertising