Martel Electronics PTC8010 - Manual (Page 23)

23
Command Description
FAULT? Returns the error code of an error that has occurred
FUNC? Returns the current mode of the calibrator
LOCAL Returns user to manual operation of the calibrator
LOCKOUT Locks out the keypad of the calibrator, and allows for remote operation only
MEAS Sets the mode for measuring of the calibrator
OUT Sets the output of the calibrator
OUT? Returns the output of the calibrator
REMOTE Puts the calibrator in remote mode
RTD_TYPE Sets the RTD type
RTD_TYPE? Returns the RTD type
RTD_WIRE Sets the number of wires used by the RTD mode.
RTD_WIRE? Returns the wire number setting used in the RTD mode
TEMP_UNIT Sets input/output temperature unit for RTD and TC
TEMP_UNIT? Returns the temperature unit for RTD and TC
TSENS_TYPE Sets temperature sensor type.
TSENS_TYPE? Returns temperature sensor type
VAL? Returns the measured values
Table 7: Parameter units
Units Meaning
MV Voltage in millivolts
V Voltage in volts
Ohms Resistance in Ohms
Cel Temperature in Celsius
Far Temperature in Fahrenheit
Kel Temperature in Kelvin
Table 8: Error codes
Error Number Error Description
100 A non-numeric entry was received where it should be a numeric entry
101 Too many significant digits entered
102 Invalid units or parameter value received
103 Entry is above the upper limit of the allowable range
104 Entry is below the lower limit of the allowable range
105 A required command parameter was missing
107 An invalid CJC_STATE was received
108 An invalid TSENS_TYPE was received