Typical power-on sequence – Agilent Technologies E5810A User Manual

Page 18

Advertising
background image

18

Chapter 1

E5810A Description
E5810 Hardware Description

Typical Power-On

Sequence

This figure shows major steps in a typical power-on sequence for an E5810
that is connected to a network that supports Dynamic Host Configuration
Protocol (DHCP) and Domain Name Service (DNS). If the network does not
support DHCP and/or DNS, the power-on sequence may be different than
that shown.

Power Applied
Display is blank, Power (Green) and Fault (Red) are ON.

169.254.58.10

Activity

LAN GPIB RS232

Power

Fault

Preset

E5810A
LAN/GPIB Gateway

Activity

LAN GPIB RS232

Power

Fault

Preset

E5810A
LAN/GPIB Gateway

Searching for DHCP Server
Display displays message, Power (Green) is ON and Fault (Red) is OFF. This typically takes
20 to 30 seconds and can take up to 150 seconds if a DHCP Server is not present.

Searching for
DHCP Server...

IP Address and Hostname Displayed
Display displays Hostname, (if known) and IP address, only Power (Green) is ON.

Activity

LAN GPIB RS232

Power

Fault

Preset

E5810A

LAN/GPIB Gateway

Hostname

IP Address

Advertising