NSi Industries E103P - Manual

TORK E101P/E103P/E120P
24 Hour Digital Time Switch
READ INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO INSTALL TIME
SWITCH SEE WARNING ON BACK PAGE - Failure to comply with instructions
could result in personal injury and/or property damage.
INSTALLATION
UNIT IS TO BE INSTALLED BY A LICENSED ELECTRICIAN
1. To remove unit from enclosure: Push tab on right to swing unit to the
left and remove.
2. Mount the enclosure at eye level using screws or other suitable fasten-
ing device. Bring supply and load wires in through bottom or side knock-
outs. DO NOT USE TOP.
3. Install 9 volt alkaline or lithium battery (not supplied) by sliding bat-
tery cover (located on top of front panel) in direction of arrow and remov-
ing. Carefully remove the battery connector and attach to battery. Insert
battery into provided space. Reinstall battery cover.
Note: Unit can be fully programmed using battery power only but should be
connected to AC power immediately after in order to save battery life.
4. Reinstall unit by reversing step #1 above and connect wires to unit
as per suggested wiring diagrams. See illustration and warning on back
page.
KEY FUNCTIONS
DAY: Press to select proper day of the week in the CLK (clock) mode
HOUR: Press to set the hours in the CLK mode and in the SCH (sched-
ule) mode.
MIN: Press to set the minutes in the CLK mode and in the SCH mode.
OVERRIDE: Press to alter the current load status (operates in both
AUTO and MAN modes).
MODE: Press to advance to next mode. Sequence is: CLK, SCH, AUTO,
MAN. In the CLK and SCH modes, UNIT AUTOMATICALLY REVERTS
TO THE AUTO MODE IF NO ENTRIES ARE MADE FOR 5 MINUTES.
DELETE: Press to delete the displayed information when in the SCH
mode.
AUTO: Press to exit from any other mode directly to the Auto mode.
ENTER: Press to store the displayed information into memory.
Information will not be stored until ENTER key is pressed.
NOTE: During settings, each press of the key will advance one num-
ber. For rapid advance, hold key in.
TO SET CLOCK
Press MODE key until display shows CLK.
Press DAY key to select current day. Press HOUR key to select current
hour. Check A (AM) or P (PM). Press MIN key to select current minute.
Press ENTER key and the clock is set for current time and day.
E100P MANUAL 11/18/03 5:00 PM Page 3