Network up, No calling id, No previous number – ADTRAN Express 4100 User Manual

Page 159: Not end2end isdn, Power up - last down cause: <reason

Advertising
background image

Appendix B. Log Messages

61200176L2-1

Express 4100/4110 User Manual

B-15

Network up

level 4

The ISDN network layer 3 is up and is ready for calls.

No calling ID

level 2

An incoming call did not provide the caller ID number required for
authentication.

No previous number

level 1

An internal error occurred with dial-on-demand function.

NOT end2end ISDN

level 4

The path that the call was routed over is not ISDN from end-to-end. This
is a warning and is most often seen for POTS calls.

Power Up - last down cause: <reason>

level 0 (displayed as level 1 after the unit is reset)

This is the <reason> for the last reset. Most are caused by internal errors.
Possible reasons are:

Bus Error

- Bad address occurred on the internal bus

Kernel error

- General operating system error

No SBCs

- Mail resources used up or lost

Router stack error

- Fatal error in protocol stack

general panic

- general error

no rip

- rip tasks could not start

out of memory

- out of available memory

out of TCP ports

- all TCP ports are used up

unknown error

- unknown fatal error has occurred

Set timer error

- Cannot set real time clock

Advertising