ADTRAN Express 4100 - Manual (Page 182)

Appendix F. Frame Relay Firmware Version
F-6 Express 4100/4110 User Manual 61200176L2-1
Link IP Address . Only one PVC may be used for translation at one
time. If more than one IP Map is configured for NAT, the first PVC
which is activated becomes the NAT port.
DLCI Mapping/IPX Map
This menu represents the IPX protocol mapping that is to take place for
this DLCI.
IPX Map/Active
Write security: 3, Read security: 5
When this is set to Yes (def), the Express 4100/4110 will attempt to
transport IPX packets for this DLCI. A setting of No means that no
IPX traffic or route will be exchanged.
IPX Map/IARP
Write security: 3, Read security: 5
When this is set to Yes (def), the Express 4100/4110 will send
Inverse ARP packets to determine the IPX network on the other end
of the virtual circuit. If the IARP is responded to, a route is placed in
the IPX route table. A setting of No means that the IPX network is to
be assigned to the link statically using the IPX Map/Link Network
parameter. The Express 4100/4110 will always respond to Inverse
ARP requests.
IPX Map/Link Network
Write security: 3, Read security: 5
This is the IPX network of the link or of the other device’s LAN.
When this DLCI becomes active, the Express 4100/4110 will add a
route to this network in the IPX routing table. This address is also
used by the Express 4100/4110 to respond to Inverse ARP requests.
If this IPX address is left as 0, the link is treated as unnumbered and
the Express 4100/4110 responds to the Inverse ARP with its Ether-
net IPX address.
DLCI Mapping/Bridge Map
This menu is used to permit bridging of packets over this DLCI. Each
DLCI or virtual circuit must be assigned a bridge group. The bridge
group treats all virtual circuits as one circuit. Bridge packets destined to
be transmitted out a particular bridge group are copied and transmitted
individually out each DLCI in the bridge group. However, incoming